Remove And Replace Ssd - Cisco NCS 1001 Hardware Installation Manual

Remove and Replace SSD

Step 5
Use the control card handle to remove the control card completely.

Remove and Replace SSD

Note
Procedure
Step 1 Loosen the two captive screws in the Removable Disk slot on the back side.
Step 2
Slide out the SSD from the Removable Disk slot.
Figure 45: Remove SSD
To replace a SSD:
Step 3 Slide the SSD into the Removable Disk slot.
Step 4
Tighten the two captive screws to secure the SSD into place.
Hardware Installation Guide for Cisco NCS 1001
48
If the SSD is removed, it needs to be physically replaced within 10 minutes. If NCS 1001 runs without the
SSD, the SSD metallic cover must be placed to close the SSD slot.
To remove a SSD:
Replace Cisco NCS 1001 Components