Cisco NCS 1001 Hardware Installation Manual page 24

Install NCS 1001-K9 into EIA/ANSI Rack
Procedure
Step 1
Identify and attach the sliding edge for the 2/4 post rack.
Step 2 Attach the sliding rail and L bracket to the left and right of the chassis using the screws (48-0471-01 and
48-2406-01) and tighten them to a torque value of 0.65 N-m (5.9 in-lbs) for 48-0471-01 screws and torque
value of 1.5 N-m (13.25 in-lbs) for 48-2406-01 screws.
Figure 16: Sliding Edge
1
2
3
Hardware Installation Guide for Cisco NCS 1001
20
Sliding edge
Screws for sliding edge (part number - 48-0471-01)
The edge always need to be facing bottom side on both the sides.
Install Cisco NCS 1001