MQ Power WHISPERWATT DCA10SPX4 Operation Manual page 30

6. The frequency meter (Figure 28) will display the
60-cycle output frequency in HERTZ.
Figure 28. Frequency Meter
7. The AC voltmeter (Figure 29) will display the
generator's output in VOLTS.
Figure 29. AC Voltmeter
8. If the voltage is not within the specified tolerance, use
the Voltage Regulator control knob (Figure 30) to
increase or decrease the desired voltage.
DECREASE
Figure 30. Voltage Regulator Control Knob
9. The AC ammeter (Figure 31) will indicate zero amps
with no load applied. When a load is applied, the
ammeter will indicate the amount of current that the
load is drawing from the generator.
Figure 31. AC Ammeter (No Load)
PAGE 30 — DCA10SPX4/DCA10SPXU4 • OPERATION MANUAL — REV. #2 (10/11/22)
GENERATOR START-UP PROCEDURE
INCREASE
10. Place ALL circuit breakers in the ON position
(Figure 32).
Figure 32. Circuit Breakers (ON)
11. Observe the generator's AC ammeter (Figure 33) and
verify it reads the anticipated amount of current with
respect to the load. The ammeter will only display a
current reading if a load is in use.
Figure 33. AC Ammeter (Load)
12. The generator will run until manually stopped or an
abnormal condition occurs.