MQ Power WHISPERWATT DCA10SPX4 Operation Manual page 21

OUTPUT RECEPTACLE PANEL FAMILIARIZATION
120-Volt AC GFCI Receptacle
NOTICE
It is recommended that the GFCI receptacle be tested
when the generator is initially uncrated. The receptacle
should then be tested daily at startup.
There is one 120-volt, 20-amp GFCI (duplex NEMA
5-20R) AC receptacle (Figure 7) located on the output
receptacle panel. This receptacle is protected by a 20-amp
circuit breaker which is located on the control and operation
panel.
Press the Reset button (Figure 7) to reset the GFCI
receptacle after it has been tripped. Press the Test button
in the center of the receptacle to check the GFCI function.
The receptacle should be tested at least once a month.
Refer to the Maintenance section for further testing of the
GFCI receptacle.
RESET
BUTTON
Figure 7. 120-Volt GFCI Receptacle
120-Volt AC L5-30R Twist-Lock Receptacle
There is one 120-volt, 30-amp, L5-30R, twist-lock AC
receptacle (Figure 8A) located on the output terminal
panel. This receptacle is protected by a 30-amp circuit
breaker located on the control and operation panel.
A
120 VAC 240 VAC
30 AMPS 30 AMPS
L5-30R L6-30R
Figure 8. Twist-Lock Receptacles
DCA10SPX4/DCA10SPXU4 • OPERATION MANUAL — REV. #2 (10/11/22) — PAGE 21
TEST
BUTTON
STATUS
LED
C
240/120 VAC
B
50 AMPS
CS6369
240-Volt AC L6-30R Twist-Lock Receptacle
There is one 240-volt, 30-amp, L6-30R, twist-lock AC
receptacle (Figure 8B) located on the output terminal
panel. This receptacle is protected by a 30-amp circuit
breaker located on the control and operation panel.
Dual-Voltage 240/120-Volt AC
CS6369 Twist-Lock Receptacle
There is one 240/120-volt, 50-amp, CS6369, twist-lock
AC receptacle (Figure 8C) located on the output terminal
panel.This receptacle is protected by a 50-amp circuit
breaker located on the control and operation panel.
NOTICE
The GFCI and twist-lock power receptacles can only
be accessed when both the main and associated circuit
breakers are in the ON position.