Default Settings Of The Machine; Setting Date And Time - Kyocera ECOSYS PA4500cx Operation Manual

Installing and Setting up the Machine > Default Settings of the Machine

Default Settings of the Machine

The default settings of the machine can be changed in System Menu. Before using this machine, configure such
settings as date and time, network configuration, and energy saving functions as needed.
NOTE
For settings that are configurable from System Menu, refer to the following:
➡
System Menu (page 178)

Setting Date and Time

Follow the steps below to set the local date and time at the place of installation. When you send an E-mail using
the transmission function, the date and time as set here will be printed in the header of the E-mail message. Set
the date, time and time difference from GMT of the region where the machine is used.
NOTE
• To make changes after this initial configuration, refer to the following:
➡
Date Setting (page 225)
• The correct time can be periodically set by obtaining the time from the network time server.
➡
Command Center RX User Guide
1
Display the screen.
[Menu] key > [
2
Configure the settings.
Select [Date] > [Time] > [Date Format] > [Time Zone]
[Date]
Set the date for the location where you use the machine.
Value: Year (2000 to 2035), Month (1 to 12), Day (1 to 31)
[Time]
Set the time for the location where you use the machine.
Value: Hours (0-23), Minutes (0-59), Seconds (0-59)
[Date Format]
Select the display format of year, month, and date. The year is displayed in Western notation.
Value: [Month/Day/Year], [Day/Month/Year], [Year/Month/Day]
[Time Zone]
Set the time difference from GMT. Choose the nearest listed location from the list. If you select a region
that utilizes summer time, configure settings for summer time.
][ ] key > [Device Common] > [OK] key > [ ][ ] key > [Date Setting] > [OK] key
44