Table of Contents
Advertisement
Operation
Starting up the projector
1. Plug the power cord. Turn on the power outlet switch
(where fitted). The power indicator on the projector
lights orange after power has been applied.
2. Press
to start the projector. The power indicator
flashes green and stays green when the projector is
on.
The start up procedure takes about 30 seconds. In
the later stage of start up, a startup logo is projected.
(If necessary) Rotate the focus ring to adjust the
image clearness.
3. If the projector is activated for the first time, select
your OSD language following the on-screen
instructions.
4. If you are prompted for a password, press the arrow
keys to enter a 6-digit password. See
password function on page
5. Switch all of the connected equipment on.
The projector will search for input signals. The current
input signal being scanned appears. If the projector
does not detect a valid signal, the message "No Signal" will continue displaying until an input
signal is found.
You can also press SOURCE to select your desired input signal. See
page
24.
• Please use the original accessories (e.g. power cord) to avoid possible dangers such as electric shock
and fire.
• If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds
before energizing the lamp.
• The Setup Wizard screenshots are for reference only and may differ from the actual design.
• If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the
message "Out of Range" displayed on the background screen. Please change to an input signal which is
compatible with the projector's resolution or set the input signal to a lower setting. See
page
58.
• If no signal is detected for 3 minutes, the projector automatically enters saving mode.
20 Operation
Utilizing the
22.
Switching input signal on
Timing chart on
Advertisement
Table of Contents
