BenQ LK935 User Manual page 48

Security Settings
Network Settings
Projector ID
Setting
48 Menu operation
• Panel Key Lock
With the control keys on the projector and remote control locked, you can
prevent your projector settings from being changed accidentally (by
children, for example). When the Panel Key Lock is on, no control keys on
the projector and remote control will operate except
To release panel key lock, press and hold
or remote control for 3 seconds.
If you turn off the projector without disabling panel key lock, the projector will still be in
locked status the next time it is turned on.
• Password/Power On Lock
See Utilizing the password function on page 22.
• Wired LAN
See Controlling the projector through a Wired LAN environment on page
24.
• AMX Device Discovery
When this function is On, the projector can be detected by AMX controller.
• MAC Address (Wired)
Displays the mac address for this projector.
Sets the projector ID for this projector (between 01~99). When multiple
adjacent projectors are in operation at the same time, switching the
projector ID codes can prevent interference from other remote controls.
After the Projector ID is set, switch to the same ID for the remote control to
control this projector. See
Set the ID
1. Press and hold ID SET until the ID setting indicator lights up.
2. Enter the ID for the remote control (between 01~99). The remote
control ID should be the same as the corresponding projector ID.
3. The ID is saved successfully when you see the ID setting indicator
starts flickering and then blackout.
Clear the ID
1. Press and hold ID SET until the ID setting indicator lights up.
2. Press ALL to clear current ID setting of the remote control.
• The ID is cleared successfully when you see the ID setting indicator starts
flickering and then blackout.
(the right key) on the projector
Projector & Remote control on page 8.
POWER.