Table of Contents
Advertisement
12. ALL
Press and hold ID SET until the ID setting
indicator lights up. Press ALL to clear
current ID setting of the remote control.
The ID is cleared successfully when you
see the ID setting indicator starts flickering
and then blackout.
13. ZOOM+/ZOOM-
Magnifies or reduces the projected picture
size.
14. ID setting indicator
15. QUICK INSTALL
Quickly selects several functions to adjust
the projected image and displays the test
pattern.
16. INFO
Displays the projector information.
17. LIGHT SOURCE
Selects an available light mode.
18. BLANK
Used to hide the screen picture.
Do not block the projection lens from
projecting as this could cause the
blocking object to become heated and
deformed or even cause a fire.
Remote control effective range
The remote control must be held at an angle within 30 degrees perpendicular to the projector's
IR remote control sensor(s) to function correctly. The distance between the remote control and
the sensor(s) should not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote control and the IR sensor(s) on the
projector that might obstruct the infra-red beam.
• Operating the projector from the front
19. LIGHT
Turns on the remote control backlight for a
few seconds. To keep the backlight on,
press any other key while the backlight is
on. Press the key again to turn the
backlight off.
20. ID SET
Sets the code for this remote control.
Press and hold ID SET until the ID setting
indicator lights up. Enter the ID for the
remote control (between 01~99). The
remote control ID should be the same as
the corresponding projector ID. The ID is
saved successfully when you see the ID
setting indicator starts flickering and then
blackout.
21. 3D
Displays the 3D menu.
22. FREEZE
Freezes the projected image.
23. PAGE+/PAGE-
No function.
• Operating the projector from the top
Introduction
9
Advertisement
Table of Contents
