Connectors; Rear Panel Connectors - Aaeon EMB-BT4 Manual

2.8

Connectors

2.8.1

Rear panel connectors

1 2
1. DC power connector. Insert the power adapter into this port.
2. USB 2.0 ports. These two 4-pin Universal Serial Bus (USB) ports are
available for connecting USB 2.0/1.1 devices.
NOTE: Before you install Windows 7 operating system, go to BIOS Setup >
Advanced > XHCI mode [Disabled], USB 2.0 (EHCI) support [Enabled], and set
them back when you finish installing the operating system. .
3. USB 3.0 ports. These two 9-pin Universal Serial Bus (USB) ports connect to
USB 3.0/2.0 devices.
NOTES:
•
•
•
•
4. LAN2 (RJ-45) ports. This port allows Gigabit connection to a Local Area
Network (LAN) through a network hub. Refer to the table below for the LAN2
port LED indications.
LAN port LED indications
ACT/LINK LED
Status
OFF
ORANGE
BLINKING
2-12
3 4
DO NOT connect a keyboard / mouse to any USB 3.0 port when installing
Windows operating system.
®
Due to USB 3.0 controller limitation, USB 3.0 devices can only be used
under Windows OS environment and after the USB 3.0 driver installation.
®
USB 3.0 devices can be used for data storage only.
We strongly recommend that you connect USB 3.0 devices to USB 3.0
ports for a faster and better performance from your USB 3.0 devices.
Description
No link
Linked
Data activity
5
SPEED LED
Status Description
10 Mbps connection
OFF
ORANGE 100 Mbps connection
1 Gbps connection
GREEN
6 7
Activity Link
LED
8
Speed
LED
LAN port
EMB-BT4