Aaeon EMB-BT4 Manual page 31

16. Serial ATA 3.0Gb/s connectors (7-pin SATA3G_1, SATA3G_2)
These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and
optical drives via Serial ATA 3.0 Gb/s signal cables.
EMB-BT4 SATA 3.0Gb/s connectors
NOTE:
• You must install Windows® XP Service Pack 3 or later version before using
Serial ATA hard disk drives.
• When using hot-plug and NCQ, set the SATA Mode Selection item in the
BIOS to [AHCI]. See section 3.3.7 IDE Configuration for details
18. VGA connector (16-pin VGA)
This 16-pin connector is for a VGA monitor or other VGA-compatible devices.
EMB-BT4 VGA Port connector
Chapter 2: Motherboard information
GND
RSATA_RXP2
RSATA_TXP1
RSATA_RXN2
RSATA_TXN1
GND
RSATA_TXN2 RSATA_RXN1
RSATA_TXP2
RSATA_RXP1
GND
VGA1
GND_Shield
DDC_CLK
VGA_VSYNC
VGA_HSYNC
DDC_DATA
(NC)
GND / HPD
+5V
PIN 1
GND
GND
GND
GND_BLUE
GND_GREEN
GND_RED
GND
(NC)
VGA_BLUE
VGA_GREEN
VGA_RED
2-23