Table of Contents
Advertisement
9.
Minicard connector
Use this connector to connect a Minicard reader.
EMB-BT4 MINICARD connectors
NOTE: The Mini-card module is purchased separately.
10. USB 2.0 connector (10-1 pin USBHUB_34, USBHUB_56 and USBHUB_7)
These USB connectors comply with USB 2.0 specifications.
EMB-BT4 USB2.0 connectors
Never connect a 1394 cable to the USB connector. Doing so will damage the
motherboard.
NOTES:
•
The USB module cable is purchased separately.
•
Before you install Windows 7 operating system, go to BIOS Setup >
Advanced > XHCI mode [Disabled], USB 2.0 (EHCI) support [Enabled],
and set them back when you finish installing the operating system.
Chapter 2: Motherboard information
MINI_CARD1
MINI_CARD2
USBHUB_34
PIN 1
USBHUB_7
USBHUB_56
(NC)
GND
GND
GND
USB5+
GND
USB5-
USBD+
+5V
USBD-
+5V
PIN 1
GND
USB6+
USB6-
+5V
PIN 1
2-19
Advertisement
Table of Contents
