Table of Contents
Advertisement
PROBLEM
Self Clean function (some models only)
During a Self Clean
cycle, the oven is louder
than usual.
The display shows - -
The display shows
DOOR.
The display shows
:
but the oven door
will not open.
At a point during a Self
Clean cycle, the function
dial halo goes out
and the temperature
indicator starts
displaying cascading
bars
.
Double oven models
only:
I cannot select the Self
clean function.
TROUBLESHOOTING
POSSIBLE CAUSES
This is normal: the oven's cooling fans operate at their highest
speed.
The meat probe mode has
been selected but the meat
probe is not plugged in to the
socket.
The door has not been properly
closed.
The oven door is locked
because the oven is still too hot
to be used for cooking.
This is normal: the oven is
in the last phase of the Self
Clean cycle, cooling down.
One oven is already turned on
or set for automatic cooking.
WHAT TO DO
Ensure the meat probe is
plugged into the socket.
Cancel meat probe by
pressing the cancel
button.
Make sure you close the
door properly.
Wait until the Self Clean
cycle has finished. If you
cancelled a Self Clean
cycle which was already
underway, the oven
still needs to cool down
before it can be used.
The oven door will
automatically unlock.
Wait until the Self Clean
cycle has finished. A
long tone will sound
and the oven door will
automatically unlock when
the oven is ready to use.
You cannot start a Self
Clean cycle when one oven
already has a function
selected.
Turn the function dial to Off
and try again.
47
Advertisement
Table of Contents
