Fagor IO-HOB-1196 Instruction Manual page 54

OPERATION
Keeping food warm
Keep warm function allows for keeping food warm on a cooking zone. The selected cooking zone
operates at a low heat setting. Cooking zone's heat setting is automatically adjusted so that food
temperature is kept at a constant temperature of 65°C. Thanks to this, ready to serve, warm food
retains its taste and does not stick to the pot's bottom. This function can be also used to melt butter
or chocolate. For the keep food warm function to operate correctly, use a flat base pot or frying pan,
so that base temperature is accurately measured by the temperature sensor fitted in the cooking
zone.
The Keep Warm function can be activated for any cooking zone.
Due to a risk of the growth of microorganisms, it is not recommended to keep food warm for a long
time, so the Keep Warm function is switched off after 2 hours.
Keep warm setting is an additional heat setting available between „0" and „1" and is indicated
on the display as „
Keep warm setting is activated in the same way as described in the section „Switching on
the cooking zones".
Keep warm setting is deactivated in the same way as described in the section „Switching off
the cooking zones".
Stop'n go function (pause II)
Stop'n go function acts like a pause. The Stop'n go function simultaneously suspends opera-
tion of all cooking zones and then resumes at the heat settings that were previously set.
In order to activate the Stop'n go function, at least one cooking zone must be in use. Next,
touch the Stop'n go function sensor field (7). „II" will be shown on all cooking zone displays (3)
and an LED pilot light will light up above the Stop'n go function sensor field (7).
In order to deactivate the Stop'n go function, touch the Stop'n go function sensor field (7)
again. The LED pilot light will start flashing and then touch any cooking zone selection sensor
field (3). Cooking zone displays (3) will show the heat setting that was previously set before
activation of the Stop'n go function.
The Stop'n go function can be activated for a maximum of 10 minutes. If the
Stop'n go function is not deactivated within this time, the appliance or will
switch itself off.
If the appliance was accidentally switched off using the on/off sensor (1), the Stop'n go function
makes it possible to quickly restore the settings. To restore the settings after the appliance has
been switched off using the on/off sensor (1), touch the on/off sensor (1) again within 6 seconds.
„0" will be shown on all cooking zone displays (3) and the LED pilot light will start flashing above
the Stop'n go function sensor field (7). Then, during the next 6 seconds, touch the Stop'n go
function sensor field (7). Cooking zone displays (3) will show the heat setting that was previously
set before the appliance was accidentally switched off.
54
".