Fagor IO-HOB-1196 Instruction Manual page 51

OPERATION
Automatic warm-up function
● Select the required cooking zone (3) so
that the display shows „0." (the dot is on).
● Select the heat setting „9" by sliding your
finger across the heat setting selection
sensor field (2).
● Touch the heat setting selection sensor
field (2) again to confirm the selected heat
setting „9". The display will immediately
show the letter „
● Now, select the desired heat setting by
sliding your finger across the heat setting
selection sensor field (2).
The display of the relevant cooking zone
will alternate between showing the letter
A
and the desired heat setting selected.
After a certain time of operation at boosted
power, the cooking zone switches back to
the heat setting set, which will be shown
on the display.
If automatic warm-up function is acti-
vated and „0" heat setting is selected
or no heat setting selection is made
within 3 seconds, the automatic
warm-up function will deactivate.
If a pot is lifted from the cooking
zone and replaced before the
warm-up countdown is completed,
the warm-up function will resume
and countdown will continue until
completed.
To activate the automatic warm-up function, touch cooking zone selection sen-
sor field (3) when heat setting "9" is selected, then select heat setting "9" by
touching the heat setting selection sensor field (2).
If you do not wish to activate the automatic warm-up function, select heat set-
ting "1" to "8" by touching the heat setting selection sensor field (2).
A
".
Cooking heat
Length of the auto-
matic warm-up
setting
(minutes)
1
2
3
4
5
6
7
8
9
-
0,8
2,4
3,8
5,2
6,8
2,0
2,8
3,6
0,2
51