Fagor IO-HOB-1196 Instruction Manual page 47

OPERATION
Control Panel
The touch control sensor panel is equipped with new generation (3.4) „DIGI Select-Sensor" sensor
fields, where the cooking zone display is also the cooking zone selection sensor and the timer.
Heat setting selection sensor (2) is a slider type touch control sensor allowing selection of heat
setting (1-9) and timer setting (1-99) by touching and sliding your finger across the marked area (2):
• sliding right - increase the heat setting
• sliding left - reduce the heat setting.
It is also possible to select the heat setting directly by touching the appropriate part of the heat
setting selection sensor field (2).
● Immediately after the appliance is connected to electrical mains, all displays will light up
briefly. Your induction hob is then ready for use.
● The induction hob is equipped with electronic touch control sensor fields, which are operated
by touching with a finger for at least 1 second.
● Touching of a sensor field is accompanied by an acoustic signal to acknowledge.
No objects should be placed on the sensor fields (this could cause an error). Touch
sensor fields should be always kept clean.
Switching on the appliance
To switch on the appliance touch and hold the on/off sensor field (1) for at least 1 second. The
appliance is switched on and the LED pilot light comes on above the on/off sensor field (1)
while all displays (3, 4) show „0".
If none of the sensor fields is touched within 20 seconds, the appliance
switches itself off.
Switching on the cooking zones
Once the appliance is switched on using the on/off sensor field (1), select a cooking zone (3)
within the next 20 seconds.
1. When a cooking zone selection sensor field (3) is touched (3), the relevant heat setting indi-
cator display shows „0" and a dot.
2. To select the desired heat setting, slide your finger across the heat selection sensor field (2).
If none of the sensor fields is touched within 20 seconds of switching on the
appliance, the cooking zone switches off.
A cooking zone is active when its display shows a digit or a letter and a decimal point.
This indicates the cooking zone is ready for the heat setting to be set or changed.
47