Adjusting the Cut Depth
If the cutter blade is becoming less sharp or half cutting is too deep, adjust the
depth of the cut. Adjustment can be set for both "Half cut" and "Full cut. "
Changing the Cut Depth for Half Cut
■
The cut depth for half cut can be set for each type and size print media. The default
setting is set to "Normal. "
NOTE
• If cutting is diffi cult depending on the material of the print media, adjust the motion of the
(P.97)
cut.
[Example] The half cut of the label tape (12 mm) is too deep (or too shallow), so
adjust the half cut depth.
1
Press the [Option] key.
2
Use [
] or [
▲
3
Use [
] or [
▲
4
Use [
] or [
▲
] to select "Print adjust" and press the [Enter] key.
▼
] to select " Half Cut Depth, " and then press the [Enter] key.
▼
] to select "Label, " and press the [Enter] key.
▼
O p t io n
H al f C u t D e p th
92
Fi l e
Pr i n t a d j u s t
S e t t i n g
Hal f C u t D e p t h
Hal f C u t M o t io n
F u l l Cu t De p t h
Shrink tube
Label
Clear tube