Table of Contents
Advertisement
Figure 47. Installing the optical drive (for M700z)
Figure 48. Installing the optical drive (for M800z)
12. If you have disconnected the signal cable and the power cable, reconnect them to the storage drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 142.
Replacing the integrated camera
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the integrated camera, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer stand. See "Replacing the computer stand" on page 96.
4. Remove the computer cover. See "Removing the computer cover" on page 101.
5. Disconnect the integrated-camera cable from the integrated camera.
112
ThinkCentre M700z and M800z Hardware Maintenance Manual
Advertisement
Table of Contents
