4. Loosen the screw
1
Figure 25. Removing the tilt-only monitor stand from the base
5. Insert the screw
1
tighten the screw to secure the monitor stand.
Figure 26. Installing the tilt-only monitor stand on the base
6. Insert the two hooks
cover as shown. Then, pivot the tilt-only monitor stand downward until it snaps into position.
Figure 27. Installing the tilt-only monitor stand on the computer cover
Replacing the UltraFlex II Stand (for M800z)
To replace the UltraFlex II Stand, do the following:
on the base, and then remove the tilt-only monitor stand from the base as shown.
on the base into the corresponding hole in the new tilt-only monitor stand. Then,
1
on the new tilt-only monitor stand into the corresponding holes in the computer
.
Chapter 9
Installing or replacing hardware
99