Table of Contents
Advertisement
Hazardous moving parts. Keep fingers and other body parts away.
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with
one of these parts, contact a service technician.
To replace the power supply assembly, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer stand. See "Replacing the computer stand" on page 96.
4. Remove the computer cover. See "Removing the computer cover" on page 101.
5. Remove the system-board shield. See "Replacing the system-board shield" on page 102.
6. Remove the VESA mount bracket. See "Replacing the VESA mount bracket" on page 104.
7. Locate the power supply assembly. See "Computer components" on page 33.
8. Disconnect the power supply assembly cables from the power supply assembly connector on the
system board and the power cord connector. See "Parts on the system board" on page 41.
106
ThinkCentre M700z and M800z Hardware Maintenance Manual
Advertisement
Table of Contents
