Antenna & Cordless Pcb Assy (For Models With Cordless Handset) - Brother FAX1960C Service Manual

6.1.8 Antenna & Cordless PCB ASSY (for models with cordless handset)
(1) Remove the two TORX screws from the cordless PCB shield and take it off the PCB.
(2) Remove the screw that secures the grounding wire and the main PCB shield together.
(3) Disconnect the cordless PCB flat cable from the PCB.
NOTE: After disconnecting the flat cable(s), check that each cable is not damaged at its end or
short-circuited. When connecting the flat cable(s), do not insert it at an angle. After insertion,
check that the cable is not at an angle.
(4) Remove the screw from the antenna support, then take the antenna and its support off the inner
frame together with the cordless PCB.
Taptite, cup B
M3x12
Antenna support
Taptite, cup B
M3x10
Ink absorber box
Main PCB shield
Antenna
Inner frame
6-24
Taptite, TORX pan B
M3x10
Cordless PCB shield
Cordless PCB
Cordless PCB flat cable
Lower cover
(6_23)
Confidential