Advertisement
• After mounting the flat cable support plate, pass the ink supply tubes between the tube/cable
guide and the lower cover and then through the bent section of the tube support wire as shown
below.
Bent section of
tube support wire
• After mounting the head cover, set the CR encoder strip so that the
(carriage motor side) and the
Hook the left end of the strip on the CR encoder strip support first, pass it through the CR
encoder sensor located on the head/carriage unit, then hook the right end while pushing the CR
encoder strip support inwards.
• After replacement of the head/carriage unit, check that the CR encoder strip and PF encoder disk
are free of grease and ink. If they are stained with grease or ink, replace them.
• If you replace the head/carriage unit, make adjustments specified in
Black
Yellow
Cyan
Magenta
Hook
Spring
Flat cable support plate
mark points upwards as shown on
Tube guides
When routing the ink supply tubes
through these tube guides, do not
(Rear)
overlap them with each other.
Sponge
Tube/cable guide
6-49
Lower cover
Carriage motor harness
Purge cam switch harness
Ink cartridge sensor harness
marked end is to the right
-
page
6-39.
Chapter 7, Section
(6_48)
7.2.
Confidential
Advertisement
Chapters
Troubleshooting
