Brother FAX1960C Service Manual page 183

Carriage PCB ASSY (carriage PCB with head flat cables)
(10) Unlock the connector on the carriage PCB and disconnect the carriage-head flat cable.
NOTE: After disconnecting the flat cable(s), check that each cable is not damaged at its end or
short-circuited. When connecting the flat cable(s), do not insert it at an angle. After insertion,
check that the cable is not at an angle.
(11) Release the head flat cables out of the cable guides and pull them out to the rear through the
opening provided in the lower cover as shown below.
(12) Unlatch the FFC support, which holds the three head flat cables, from the head/carriage unit.
(13) Lift up the carriage PCB ASSY.
(14) Remove the FFC support from the head flat cables.
Carriage PCB
Carriage-head flat cable
Latch
Opening
6-41
FFC support
Latch
Lower cover
Head flat cables
(6_38)
Confidential