Roland VS-2400CD Appendices page 91

*1: If Low Type (Low Type) or High Type (High Type) is set to "Shlv (Shlving Type)," the setting for Lo Q or High
Q is invalid.
Graphic Equalizer (10-Band Graphic Equalizer)
This Equalizer sets the boost/cut amount by each segment of the frequency divided into ten bands. In performing
PA at a live, this feature is useful to prevent howling by cutting the site-specific resonance frequency.
fig.08-57
Input A
Input B
Preventing howling
While performing PA at a live, follow the steps below to prevent howling. First, identify the site-specific
resonance frequency to cut its gain.
Controlling Channels A and B separately
Setting Link On enables simultaneous control on the 10-Band Parametric Equalizer via Channel B according to
the settings on the Channel A side.
To control Channels A and B separately, turn Link Off.
Parameter (full name)
Lnk (Link):
Link (Link Switch)
GEQA, GEQB (10-Band Graphic Equalizer): Models a 10-band graphic equalizer.
Sw (Switch)
31.2 – 16 k (Gain)
InputG (Input Gain)
Level (Output Level)
Output A
10BAND EQ A
Link
10BAND EQ B
Output B
Setting
Makes Channel B follow the settings for Channel A.
On, Off
On, Off
-12– +12 dB
-60– +12 dB
-60– +12 dB
Function
Specifies if Channel B follows or does not follow the
settings for Channel A.
Turns the parametric equalizer on or off.
Sets the boost/cut amount at the respective frequencies.
Sets the overall volume before passing through the
equalizer.
Sets the overall volume after passing through the equalizer.
Algorithm List
91