Stereo Flanger - Roland VS-2400CD Appendices

Stereo Flanger

fig.08-38Parameter (full name)SettingFunction
Input L
Input R
Flg (Flanger):
Sw (Switch)
Pol (Polarity)
Rate (Rate)
Depth (Depth)
Manual (Manual)
Reso (Resonance)
CrossFBLvl (Cross-Feedback Level)
FX Lvl (Effect Level).
DirLvl (Direct Level)
EQ (Equalizer)
Sw (Switch)
Low Gain (Low Gain)
Low Freq (Low Frequency)
Low Q
Low Type
Mid Gain (Middle Gain)
Mid Freq (Middle Frequency)
Mid Q (Middle Q)
High Gain
High Freq (High Frequency)
High Q
Hi Type (High Type)
Level (Output Level)
*1: An excessively great values for Resonance (Reso) may cause oscillation.
*2: An excessively large value for Cross-Feedback level may cause oscillation.
*3: When a mono source has been input, set "Inv" to provide spaciousness to the sound. Set "Sync" for inputting a
stereo source.
*4: If Low Type (Lo Type) or High Type (Hi Type) is set to "Shlv (Shlving Type)," the setting for Lo Q or High Q is
invalid.
3BAND EQ
Flanger L
Flanger R
3BAND EQ
Adds effect similar to ascending/descending sound of a jet.
On, Off
Sync, Inv
0.1–10.0 Hz
0–100
0–100
0–100
0–100
-100–100
-100–100
On, Off
-12– +12 dB
20 - 2000 Hz
0.3–10.0
Shlv, Peak
-12– +12 dB
200–8000 Hz
0.3–10.0
-12– +12 dB
1.4–20.0 kHz
0.3–10.0
Shlv, Peak
0–100
Output L
Output R
Turns the flanger on or off.
Sets the right and left phases of modulation.
Sets the rate at which the flanger is modulated.
Sets the depth of modulation.
Sets the center frequency subject to application of the
Flanger effect.
Enhances frequency components at around the center
frequency set with Manual.
Sets the amount of the flanger sound to be returned to the
channel opposite to the one used for input.
Sets the volume of the flanger sound.
Sets the volume of the direct sound.
Turns the equalizer on or off.
Sets the boost/cut amount in the low frequency band.
Sets the center frequency in the low frequency band.
Sets the width of the area around the low frequency that
will be affected by the gain settings.1
Sets the type of the low frequency band equalizer
(Shlving type or peaking type).
Sets the boost/cut amount in the middle frequency band.
Sets the center frequency in the middle frequency band.
Sets the width of the area around the middle frequency that
will be affected by the gain settings.
Sets the boost/cut amount in the High frequency band.
Sets the center frequency in the High frequency band.
Sets the width of the area around the High frequency that
will be affected by the gain settings.1
Sets the type of the High frequency band equalizer (Shlving
type or peaking type).
Sets the volume after passing through the equalizer.
Algorithm List
*3
*1
*2
*4
*4
67