Roland VS-2400CD Appendices page 37

Oscillator/Analyzer [SHIFT]+[F4 (UTILITY)] → [(Page3) F4 (OscAna)]
Oscillator
Parameter name Display
Switch Sw
Source SOURCE
Attenuator ATT
Fader Fader
Mix Send Pan PAN
Mix Send Switch MIX
AUX Send Switch AUX (1–8)
AUX Send Level -
Direct Path DIR (1–8)
*1 Metronome is not output to monitor when "METRONOME" is selected.
*2 Valid when Source is except "METRONOME."
Analyzer
Parameter name Display
Source SOURCE
Average Times AVERAGE TIMES
Average Type AVERAGE TYPE
Use Effect Board Use EFFECT Board
*1 When an effect board is being used by the analyzer, it's unavailable for other use.
Parameter Initialize [SHIFT]+[F4 (UTILITY)] → [(Page3) F6 (PrmIni)]
Parameter name Display
Initialize Section INITIALIZE SECTION
R-BUS Configuration [SHIFT]+[F4 (UTILITY)] → [(Page4) F1 (R-BUS)]
Parameter name Display
R-BUS Remote Control R-BUS Remote Control
R-BUS Configuration
[SHIFT]+[F4 (UTILITY)] → [(Page4) F1 (R-BUS)]→ [F1 (R-BUS)] *1
*1 Valid when an R-BUS equipment is connected.
* The parameters appear on screen differs according to an R-BUS equipment connected to this unit.
Value, Initial value
Off, On
PINK Noise, WhiteNoise, Sin Wave, METRONOME (*1)
-42.0–-12–+0 dB (*2)
-∞–0.0–6.0 dB
L63–C–R63
Off, On
Off, On
-∞–6.0 dB
Off, On
Value, Initial value
IN1–IN16, TR1–TR24, FX1–4 RTN L, FX1–4 RTN R, Gen/OSC, MST L, MST R,
MON L, MON R, AUX1–8, DIR1–8
1–128
Off, NRM, EXP
Off, A, B (*1)
Value, Initial value
MIXER & UTILITY, MIXER, UTILITY
Value, Initial value
Off, On
Parameter List
37