Roland VS-2400CD Appendices page 85

Parameter (full name)
Voc (Vocoder 2):
Envelope (Envelope)
PanMode (Pan Mode)
Hold (Hold)
MicSens (Microphone Sensitivity)
SynInLvl (Synthesizer In Level)
Character Ch1 – 19
(Voice Character Channels 1 - 19)
Mic (Microphone Mix)
MicHPF (Microphone HPF)
MicPan (Microphone Pan)
NSThresh (Noise Suppressor Threshold)
Cho (Chorus):
Sw (Switch)
Rate (Rate)
Depth (Depth)
PreDly (Pre-Delay)
MixBal (Mix Balance)
Setting
The pitch is specified as in the instrumental sound while the tone is output in
the human voice.
Sharp, Soft, Long
Mono, Stereo, L→R, R→L Defines how the sound is located.
On, MIDI
0–100
0–100
0–100
0–100
Thru, 1.0–20.0 kHz
L63–R63
0–100
Adds spaciousness and depth to the sound.
On, Off
0.1–10.0 Hz
0–100
0–50 ms
0–100
Algorithm List
Function
Defines characteristics of the sound.
Specifies that an instrumental sound is or is not issued
with the formant fixed.
Sets the input sensitivity of the microphone.
Sets the input level of the instrumental sound.
Sets the tone of the vocoder.
Sets the amount of the sound after passing through the
microphone HPF should be mixed into the Vocoder
output.
Sets the frequency at which HPF on the vocal sounds
through the microphone starts taking effect.
Sets this to "Thru" if HPF is not desired.
Sets the panning of vocal sounds through the
microphone.
Sets the volume to start muting noise on the
instrumental sound input.
Turns the chorus on or off.
Sets the rate of modulation.
Sets the depth of modulation.
Sets the time delay from when the direct sound begins
until the chorus sound is heard.
Sets the volume balance between the chorus sound
and the direct sound.
85