Roland VS-2400CD Appendices page 51

Parameter (full name)
GRev (Gate Reverb):
Sw (Switch)
Mode (Gate Mode)
Time (Gate Time)
PreDLY (Pre-Delay)
Thick (Thickness)
Densty (Density)
AcDLY (Accent Delay Time)
AcLvl (Accent Level)
AcPan (Accent Pan)
FX Lvl (Effect Level).
DirLvl (Direct Level)
EQ (Equalizer)
Sw (Switch)
Low Gain (Low Gain)
Low Freq (Low Frequency)
Low Q
Low Type
Mid Gain (Middle Gain)
Mid Freq (Middle Frequency)
Mid Q (Middle Q)
High Gain
High Freq (High Frequency)
High Q
Hi Type (High Type)
Level (Output Level)
*1: If Low Type (Lo Type) or High Type (Hi Type) is set to "Shlv (Shlving Type)," the setting for Lo Q or High Q is
invalid.
* "Gate Reverb" cannot be used on EFFECT2 and 4 (even-numbered effects).
* "Gate Reverb" cannot be used on the projects with 64kHz or higher sampling rate.
Setting
Mutes the revert sound midway.
On, Off
See the column on
the previous page.
10–400 s
0–300 ms
0–100
0–100
0–200 ms
0–100
L63–R63
-100–100
-100–100
On, Off
-12– +12 dB
20 - 2000 Hz
0.3–10.0
Shlv, Peak
-12– +12 dB
200–8000 Hz
0.3–10.0
-12– +12 dB
1.4–20.0 kHz
0.3–10.0
Shlv, Peak
0–100
Function
Turns the gate reverb on or off.
Defines how the reverb sound is applied.
Sets the time from when the reverb sound begins until it is
muted.
Sets the time until the reverb sound appears.
Sets the thickness of the reverb sound.
Sets the density of the reverb sound.
Sets the time from when the reverb sound is muted until the
accent sound appears.
Sets the volume of the accent sound.
Sets the pan of the accent sound.
Sets the volume of the gate reverb sound.
Sets the volume of the direct sound.
Turns the equalizer on or off.
Sets the boost/cut amount in the low frequency band.
Sets the center frequency in the low frequency band.
Sets the width of the area around the low frequency that
will be affected by the gain settings.1
Sets the type of the low frequency band equalizer
(Shlving type or peaking type).
Sets the boost/cut amount in the middle frequency band.
Sets the center frequency in the middle frequency band.
Sets the width of the area around the middle frequency that
will be affected by the gain settings.
Sets the boost/cut amount in the High frequency band.
Sets the center frequency in the High frequency band.
Sets the width of the area around the High frequency that
will be affected by the gain settings.1
Sets the type of the High frequency band equalizer (Shlving
type or peaking type).
Sets the volume after passing through the equalizer.
Algorithm List
*1
*1
51