12 SERVICE WORK ON THE CHASSIS
12.9
66
K00546-10
Removing the lower triple clamp
E00380-10
E00381-10
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
M8
brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and
5
tighten screws
.
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
(EXC‑F EU/AU)
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
(
–
Remove front fender. (
–
Remove the handlebar cushion.
Main work
–
Open the cable holder in front of the right radiator and detach
the wiring harness.
–
1
Remove screws
and hang the voltage regulator to the side.
–
Open the cable holder in front of the left radiator and detach
the wiring harness.
–
2
Loosen screw
.
–
3
Remove screw
.
–
Take off the upper triple clamp with the handlebar and set it
aside.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
4
Remove O-ring
and protective ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
25 Nm (18.4 lbf ft)
Loctite
(
p. 109)
p. 120)
p. 121)
p. 119)
p. 62)
(
p. 108)
p. 64)
p. 74)
5
.
4
.
®
243™