13 BRAKE SYSTEM
106
–
Stand the vehicle upright.
–
Remove screw cap
–
Press the brake piston back to its basic position and make sure
that no brake fluid overflows from the brake fluid reservoir,
extracting it if necessary.
Info
Make sure when pushing back the brake piston that you
do not press the brake caliper against the spokes.
K00566-10
–
Remove cotter pins
brake linings.
–
Clean the brake caliper and brake caliper support.
E00351-10
–
Check that leaf spring
6
plate
in the brake caliper support are seated correctly.
E00352-10
–
Insert the new brake linings, insert the pin, and mount the cot-
ter pins.
Info
Always change the brake linings in pairs.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
E00353-01
1
with membrane
2
and the O-ring.
3
4
, pull out pin
, and remove the
5
in the brake caliper and sliding