18 SERVICE WORK ON THE ENGINE
138
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
–
Mount and tighten oil drain plug
new seal ring.
Guideline
Oil drain plug with
magnet
H01708-10
–
Remove screws
H01709-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surface.
H01710-10
–
Lay the motorcycle on its side and fill the oil filter housing to
about ⅓ full with engine oil.
–
Insert the new oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it together with
oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
H01711-10
–
Stand the motorcycle upright.
–
Remove filler plug
O-ring, and fill up with engine oil.
Engine oil
Info
Too little engine oil or poor-quality engine oil will result
in premature wear of the engine.
H01713-10
–
Mount and tighten the filler plug together with the O-ring.
3
with the O-ring.
M20x1.5
1
with the magnet and a
M12x1.5
5
. Remove the oil filter cover with the O-ring.
6
out of the oil filter housing.
7
.
M6
8
from the clutch cover together with the
1.2 l
(1.3 qt.)
15 Nm (11.1 lbf ft)
20 Nm (14.8 lbf ft)
10 Nm (7.4 lbf ft)
Engine oil
(SAE 10W/50)
(
p. 157)