Table of Contents
Advertisement
Security Function Ver. 1.01 May 2016
7.
Enhancing the security function
• Perform the Enhanced Security Mode procedures while making checks of installation
checklist in User's Guide [Security Operations].
• To make the Enhanced Security Mode, service settings must first be made. Make the
necessary service settings and check that they have been correctly made.
7.1
Details of settings
Item
CE Authentication
CE Password
Image Controller Setting
HDD installation setting
Management Function Choice
NOTE
• If any one of the above functions is not set properly, the machine does not allow
the Enhanced Security setting to be made.
• The CE password must be set to any value other than the default one.
• If fax functions are to be used, check that the fax kit has been mounted and set up
properly.
See P.43
• In addition to setting the Enhanced Security Mode, the service engineer disables
the following functions and operates and manages the machine under a condition
in which those functions are disabled.
Item
IP Address Fax
Internet Fax
Print Function via USB Port
Setting/Check
Check the setting of [ON]
Set arbitrarily.
Check the setting of [Controller 0].
Check the setting of [Installed].
Check the setting of [Unset].
Using [Service Mode]
set [IP Address Fax] to [OFF].
Using [Service Mode]
set [Internet Fax] to [OFF].
Select [Bit Assignment: 3] or [HEX Assignment: 08] for [Service
Mode]
[System2]
[Software Switch Setting]
70]. (To restrict use of the print function via a USB port.
11
7. Enhancing the security function
Default Setting
[ON]
9272927292729272
[Controller 0]
[Installed]
[Unset]
Setting
[System 2]
[Network Fax Settings],
[System 2]
[Network Fax Settings],
[Switch No.:
Advertisement
Table of Contents
