Affixing The Labels - Konica Minolta bizhub C236DN Service Manual

Security Function Ver. 1.01 May 2016
B. When the ferrite core is installed to the supplied modular cable
1. Connect the supplied modular cable in the modular jack (LINE) of the fax kit (Line 1).
If the user is connected with a key telephone system or a private branch exchange
(PBX), do not connect the modular cable to where other than an analog line.
2. Following the steps given below, house the ferrite core of the modular cable in the
machine.
a) Hook the cable.
b) Pass the cable wound around the ferrite core through the protrusion.
3. <Only when using the telephone line>
a) Attach the supplied ferrite core to the position of the modular cable of the telephone.
Install the ferrite core by winding the cable two turns.
b) Connect the modular cable of the telephone line to the modular jack (TEL) of the fax
kit (Line 1).
c) House the ferrite core of the modular cable in the machine.
Pass the protrusion shown in the illustration below through the cable wound around the
ferrite core in step a).
Position the ferrite core so that it is placed on the base.
4. <Only when adding LINE-2>
a) Connect the supplied modular cable in the modular jack (LINE) of the fax kit (Line 2).
If the user is connected with a key telephone system or a private branch exchange
(PBX), do not connect the modular cable to where other than an analog line.
b) House the ferrite core of the modular cable in the machine.
Pass the cable wound around the ferrite core through the protrusion.
5. Route the modular cable through the harness guide.
6. <When adding no paper feed options/desk or when using the Desk DK-705>
Pass the modular cable into the hole in the lower portion of the rear right cover.
<When using the Paper Feed Cabinet PC-410/PC- 210/PC-110 or desk DK-510>
a) Remove the rear right cover from the paper feed cabinet or desk. (Two screws)
b) Remove the knockout from the rear right cover removed in step (a) using nippers.
c) Route the modular cable through the three wire saddles.
d) Route the cable through the notch and attach the rear right cover. (Two screws)
11.1.3

Affixing the labels

1. Affix the supplied label.
2. Affix the supplied label (Super G3 label).
44
11. FAX function