A
d
Image: A: Position of floor plate; B: floor plate glued to the floor
a Cap nut
b Holding plate
c Upright bolt
Requirements The floor must support the weight of the unit
The floor must be clean and suitable for the manner of fastening
Unit set up and aligned in accordance with the planning drawing
1. Insert the floor plate from the fastener set into the holding plate as
shown in the drawing.
2. Screw on the cap nuts hand-tight.
3. Align the floor fasteners in position 1-1 or 2-2 on the unit leg as
shown in the drawing and mark the floor.
4. Screw on the cap nuts and remove the holding plate from the floor
plate.
5. Fasten the floor plates to the floor with the enclosed adhesive.
6. Place the holding plate on the floor plates and fasten in place with
cap nuts.
7. Fill out the start-up operation report.
a
c
Follow the instructions of the adhesive manufacturer.
Apply the adhesive in accordance with the manufacturer's
instructions.
Observe the drying time in the manufacturer's instructions.
Installation instructions
Installing the unit
B
e
b
d Floor plate
e Unit leg
23