Table Of General Classification - Olivetti FAX System M-New Service Manual

3KH

(2) Table of general classification

Error code
U00000 No response or busy after the set number of redials.
U00100 Transmission was interrupted by a press of the stop/clear key.
U00200 Reception was interrupted by a press of the stop/clear key.
U00300 Recording paper on the destination unit has run out during transmission.
U004XX A connection was made but interrupted during handshake with the receiver unit (refer to page 1-4-
4 U004XX error code table).
U00500 Multiple communication was interrupted and call was not made on destination units after interrup-
tion.
U006XX Communication was interrupted because of a machine problem (refer to page 1-4-5 U006XX error
code table).
U00700 Communication was interrupted because of a problem in the destination unit.
U008XX A page transmission error occurred in G3 mode (refer to page 1-4-5 U008XX error code table).
U009XX A page reception error occurred in G3 mode (refer to page 1-4-5 U009XX error code table).
U010XX Transmission in G3 mode was interrupted by a signal error (refer to page 1-4-6 U010XX error code
table).
U011XX Reception in G3 mode was interrupted by a signal error (refer to page 1-4-8 U011XX error code
table).
U01400 An invalid one-touch key was specified during communication.
U01500 A communication error occurred when calling in V.8 mode.
U01600 A communication error occurred when called in V.8 mode.
U017XX A communication error occurred before starting T.30 protocol during transmission in V.34 mode
(refer to page 1-4-10 U017XX error code table).
U018XX A communication error occurred before starting T.30 protocol during reception in V.34 mode (refer
to page 1-4-10 U018XX error code table).
U02000 Relay broadcast was refused by a relay station because of a mismatch in permit ID number and
permit telephone number when a relay command was issued.
U02100 A relay command failed because the destination unit (relay station) had no relay broadcast capa-
bility.
U02200 A relay command from a command station failed because a telephone number that was not regis-
tered in the relay station was specified. Or, relay broadcast was requested to a relay station but
failed because a telephone number that was not registered in the relay station was specified. Or,
Subaddress-based relay broadcast transmission failed because the data registered in the Subad-
dress relay box was deleted.
U023XX Receiving station information was not normally received in reception of a relay command (refer to
page 1-4-10 U023XX error code table).
U02400 An interoffice subaddress-based relay transmission was interrupted because of a mismatch in the
specified relay box number.
U03000 No document was present in the destination unit when polling reception started.
U03100 In reverse polling, although no original was set in the destination unit, transmission was complete.
U03200 In confidential polling reception, data was not accumulated in the specified box in the destination
unit. Or, in interoffice subaddress-based bulletin board reception, data was not stored in the box
specified by the destination unit.
U03300 In polling reception from a unit of our make, operation was interrupted due to a mismatch in permit
ID or telephone number. Or, in interoffice subaddress-based bulletin board reception, operation
was interrupted due to a mismatch in permit ID or telephone number.
1-4-2
Description
Service Manual Y108810-2