U671 Clearing The Fax Backup Report Data; U698 Setting The Port Addressed In Maintenance Mode All; U699 Setting The Software Switches - Olivetti FAX System M-New Service Manual

Maintenance
item No.
Clearing the FAX backup report data
U671
Description
Clears the historical record of the fax and Internet-fax job as well as the reserved fax job information which are
backed up in the FAX control PWB.
Purpose
For prevention of backup data leakage.
Method
1. Press the start key.
2. Press [EXECUTE].
3. Press the start key. The backed up data is cleared.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Setting the port addressed in maintenance mode
U698
Description
Configures the port that is addressed in maintenance mode.
Purpose
To configure the port that is addressed in maintenance mode when the optional dual FAX is installed.
It is not required to assign the same settings to both ports. It should be used to assign different settings to
each port.
Remarks
This maintenance item is shown only when the optional dual FAX has been installed.
Setting
1. Press the start key.
2. Press [PORT SELECT]. The current setting is displayed in reverse.
3. Select the item to be set.
Display
ALL
P1
P2
4. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Supplement
The setting must be made after re-entering maintenance mode because it will be cleared when maintenance
mode is canceled and power is switched off.
Setting the software switches
U699
Description
Sets the software switches on the fax control PWB individually.
Purpose
To change the setting when a problem such as split output of received originals occurs.
Since the communication performance is largely affected, normally this setting need not be changed.
Method
1. Press the start key.
The port that is addressed by U698 is displayed when the optional dual FAX is installed.
2. Press [SW No.].
The current setting is displayed.
An asterisk (*) is displayed if U698 is set to [ALL] and settings for ports 1 and 2 are not identical.
3. Enter the desired software switch number (3 digits) using the numeric keys and press the enter key.
4. Use numeric keys 7 to 0 to switch each bit between 0 and 1.
5. Press the start key to set the value.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Y108810-2
Description
Description
All ports
Port 1 (Fax control PWB)
Port 2 (Optional dual FAX)
Service Manual
3KH-3
1-3-25