Ricoh Aficio CL7200 Maintenance Manual page 100

Troubleshooting
Messages
/ Second messages
Hardware Problem
HDD
Hardware Problem
IEEE1394
Hardware Problem
Option RAM
Description
The printer identified a HDD
Board error.
The printer identified an IEEE
1394 interface board error.
The printer identified an option-
al RAM error.
Solution
Turn the power off, and then on. Re-
move and re-install the HDD board
correctly. If the message appears
again, contact your sales or service
representative.
See "Attaching Printer Hard Disk Type
7100", Setup Guide.
Turn the power off, and then on.
Remove and re-install the IEEE 1394
interface board correctly.
A
Check the IEEE 1394 interface
board is correctly attached to the
computer.
B
Check the IEEE 1394 interface ca-
ble is securely connected.
C
Unplug the IEEE 1394 interface
cable which is connected to the
printer.
D
Restart the computer. If the mes-
sage appears even after executing
above operation, proceed to the
following steps.
E
Execute the utility tool for IEEE
1394 interface board that is stored
in the following path in the CD-
ROM labeled "Printer Drivers and
Utilities": UTILITY\1394
❒ For details about using the utility
tool for IEEE 1394, see the RE-
ADME file in the same directory in
the CD-ROM. If the message ap-
pears again, contact your sales or
service representative.
See "Attaching IEEE 1394 Interface
Board Type B", Setup Guide.
Turn the power off, and then on. Re-
move and re-install the optional RAM.
If the message appears again, contact
your sales or service representative.
See "Attaching Memory Unit Type C
(SDRAM Module)", Setup Guide.
100