Host Interface - Ricoh Aficio CL5000 Setup Manual

Options
H H H H
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display "IEEE
802.11b".

Host Interface:

1
IEEE 802.11b
I I I I
Press { { { { Enter #} } } } .
Be sure that "Comm. Mode" ap-
pears on the panel display.
IEEE 802.11b:
Comm. Mode
J J J J
Press { { { { Enter #} } } } .
The following message appears on
the panel display.
Comm. Mode:
*802.11 Ad hoc
K K K K
Press { { { { U U U U } } } } or { { { { T T T T } } } } to select the
transmission mode.
Note
❒ The factory default is "802.11Ad
hoc".
❒ To use an IEEE 802.11b card for
w h i c h t h e I B S S ( N e t w o r k
Name) setting is not necessary,
select "Ad hoc".
L L L L
Press { { { { Enter #} } } } .
The display returns to the previous
menu in a few seconds.
M M M M
If "802.11Ad hoc" or "Ad hoc" is
selected for "Comm. Mode", set
the channel to use for transmis-
sion.
Note
❒ Confirm the network adminis-
trator for the channel to use.
46
A Press { { { { U U U U } } } } or { { { { T T T T } } } } to display
"Channel".
IEEE 802.11b:
Channel
B Press { { { { Enter #} } } } .
The channel currently used ap-
pears on the panel display.
Channel:
(1-11)
C Press { { { { U U U U } } } } or { { { { T T T T } } } } to enter the
channel.
D Press { { { { Enter #} } } } .
N N N N
Set "Trans. Speed" in the same
way.
Note
❒ The factory default is "Auto". If
you need to change the trans-
mitting speed depending on en-
vironment you are using, select
the appropriate transmitting
speed.
O O O O
Press the { { { { U U U U } } } } or { { { { T T T T } } } } key to dis-
play "SSID", and then press the
{ { { { Enter #} } } } key.
IEEE 802.11b:
SSID
The following message appears on
the panel display.
SSID:
Enter ID
Note
❒ The factory default is "ASSID".
11