Ricoh Aficio CL5000 Setup Manual page 13

I I I I
Push in the holding handles that
you pulled out in step
J J J J
Pull out Tray 1 (standard input
tray) slowly while lifting it up a
little.
K K K K
Fasten the two screws (for the
front) as shown in the illustration.
Use a coin to fasten them tightly.
To connect two Paper Feed Units,
fasten the two screws (for the
front) as shown in the illustration.
L L L L
Close Tray 1 firmly.
G G G G
.
M M M M
Place the two metal fittings on the
back of the printer, and then fas-
ten the screws (for the rear) over
them as shown in the illustration.
ZESP008J
Use a coin to fasten them tightly.
N N N N
Stick the label above the handle
on the front of the Paper Feed
Unit.
ZESP009J
❒ After finishing installation, you
ZESP910J
PAPER FEED UNIT Type 5000
Note
can check whether the Paper
Feed Unit is installed properly.
Print the configuration page
f ro m t h e " L i s t / T e s t P ri n t "
menu. If it is installed properly,
you will see "Tray 2" or "Tray 3"
under the "Options" list.
1
ZESP010J
ZESP126J
9