Ricoh Aficio CL5000 Setup Manual page 48

Options
M M M M
Tighten the two screws that you
removed in step
controller board back into its
original position.
1
Use a coin to fasten them tightly.
N N N N
Set the dustproof filter cartridge
that you removed in step
Important
❒ Do not shake the removed car-
tridge. It may cause dust to fall
off.
44
E E E E
to fasten the
ZESPK940J
D D D D
.
ZESH761J
O O O O
Set the dustproof filter cover that
you removed in step
sert the projections on the cover to
the holes on the printer (A A A A ), and
then push it down (B B B B ).
Note
❒ After finishing installation, you
can check whether the 802.11b
Interface Unit is installed prop-
erly. Print the configuration
page from the "List/Test Print"
menu. If it is installed properly,
you will see "Installed" for
"IEEE802.11b".
❒ If the 802.11b Interface Unit is
not installed properly, "Not In-
stalled" is shown. In such a case,
reinstall from step
not install it properly even after
reinstallation, contact your sales
or service representative.
Reference
See "Using the Control Panel" in
the Administrator Reference for
printing the configuration page.
C C C C
. First, in-
ZESH218J
A
. If you can-