Paper Feed Unit Type 5000 - Ricoh Aficio CL5000 Setup Manual

PAPER FEED UNIT Type 5000

Preparation
When installing multiple options,
install the Paper Feed Unit first.
Two people are needed to install
the Paper Feed Unit. Start the in-
stallation with two people.
Up to two Paper Feed Units can be
installed to the printer. When in-
stalling two units, connect the two
units by following the procedure
for connecting the unit and the
printer. Then, place the printer on
the connected two Paper Feed
Units.
R CAUTION:
• When moving the machine,
each person should hold the
handles that are located on op-
posite sides, and then lift it slow-
ly. Lifting it carelessly or
dropping it may cause an injury.
• When moving the Paper Feed
Unit, hold the handles that are
located on the top of the unit,
and then lift it slowly. Lifting it
carelessly or dropping it may
cause an injury.
Note
❒ The printer weighs approximately
60 kg (130 lb.).
❒ The PAPER FEED UNIT weighs
approximately 15 kg (33 lb.).
❒ "Tray 2" appears on the panel dis-
play when only one unit is in-
stalled. "Tray 3" appears on the
panel display for the second unit
when two units are installed.
PAPER FEED UNIT Type 5000
A A A A
Turn off the power switch, and
then unplug the power cable.
B B B B
Hold the Paper Feed Unit as
shown in the illustration, and
then place it on a flat surface near
the place where the machines are
to be installed.
Note
❒ Be sure to work in a place with
enough space, so that you can
get in the back of the printer.
C C C C
Remove the adhesive tapes.
D D D D
Open the tray of the Paper Feed
Unit, and then remove the sup-
plied parts and the packing mate-
rials.
1
ZESP900J
ZESP140J
7