Remote Maintenance By Telnet; Using Telnet - Ricoh Aficio 1027 Network Manual

Remote Maintenance by telnet

Important
❒ Remote Maintenance should be
password-protected so that access
is allowed to administrators only.
❒ The password is the same as the
one of Web Image Monitor admin-
istrator. When the password is
changed using "mshell", other
passwords change also.
❒ Some command cannot be set de-
pending on the model type.

Using telnet

Follow the procedure below to use
telnet.
Important
❒ Only one user at a time can log on
to perform remote maintenance.
A
Use the IP address or the host
name of the machine to start telnet.
% telnet IP_address
B
Enter your user name and pass-
word.
For details about the user name
and password, consult your net-
work administrator.
For user authentication, enter a
login user name and password.
For user code authentication, enter
a user code in User Name.
Remote Maintenance by telnet
C
Enter a command.
D
Quit telnet.
msh> logout
The configuration message about
saving the changes appears.
E
Enter "yes" to save the changes,
and then press the {Enter} key.
If you do not want to save the
changes, enter "no", and then press
the {Enter} key. To make further
changes, enter "return" at the com-
mand line, and then press the {En-
ter} key.
Note
❒ If the message "Can not write
NVRAM information" appears,
the changes are not saved. Re-
peat the procedure above.
❒ When the changes are saved,
the network interface board is
reset automatically with that
changes.
❒ When the network interface
board resets, the print job in
print process will be printed.
However, print jobs in queue
will be canceled.
2
59