Configuring The Energy Saver Mode; Setting A Password - Ricoh Aficio 1027 Network Manual

Monitoring and Configuring the Printer
Configuring the Energy Saver
Mode
Follow the procedure below to con-
figure Energy Saver mode.
A
Start SmartDeviceMonitor for Admin.
2
B
On the [Group:] menu, point to
[Yes], and then click [TCP/IP],
[IPX/SPX] or [TCP/IP SNMPv3].
A list of machines using the select-
ed protocol appears.
Select the protocol of the machine
whose configuration you want to
change.
If you are using TCP/IP SNMP v3,
enter the user authentication.
C
Select the machine whose set-
tings you want to make.
To make settings for all machines
in the selected group, select no ma-
chine.
D
On the [Group:] menu, point to [En-
ergy Saver Mode], point to [Set Indi-
vidually] to make the settings for
only the selected machine or
point to [Set By Group] to make the
settings for all machines in the se-
lected group, and then click [On]
or [Off].
E
Quit SmartDeviceMonitor for Admin.
Note
❒ For details about the setting for
Energy Saver mode, see Smart-
D e v i c e M o n i t o r f o r A d m i n
Help.
48

Setting a Password

Follow the procedure below to set a
password.
A
Start SmartDeviceMonitor for Admin.
B
On the [Group:] menu, point to
[Search Device], and then click
[TCP/IP], [IPX/SPX] or [TCP/IP SNMPv3].
A list of machines using the select-
ed protocol appears.
Select the protocol of the machine
whose configuration you want to
change.
If you are using TCP/IP SNMP v3,
enter the user authentication.
C
In the list, select a machine whose
c o n f i g u r a t i o n y o u w a n t t o
change.
D
On the [Tools] menu, click [NIB Set-
up Tool].
A Web browser opens and the dia-
log box for entering the login user
name and password for the Web
Image Monitor administrator ap-
pears.
NIB Setup Tool starts when the net-
work interface board is default. Fol-
low the instructions on the screen.
E
Enter the login user name and
password, and then click [Login].
For details about the user name
and password, consult your net-
work administrator.
F
Click [Configuration].
G
Click [Program / Change Administra-
tor] on the [Device Settings] area,
and then change the settings.
H
Quit Web Image Monitor.
I
Quit SmartDeviceMonitor for Admin.