Enter Dealer Calibration Mode; Set The Vessel Type - Raymarine SmartPilot ST6001 Commissioning Manual

Chapter 2: SmartPilot Commissioning

Enter Dealer Calibration mode

As improper use of the Dealer Calibration settings can seriously impair SmartPilot
performance, we have made entry to the Dealer Calibration mode more difficult.
Ensure you follow the instructions in this step carefully.
1. Start with the SmartPilot in STANDBY mode.
2. Enter DEALER CAL as follows:
ST6001/ST6002 Controllers
• press and hold the standby key for two
seconds to enter the Calibration mode
• when the screen shows
press the disp key until you see the
DEALER CAL
• press the auto key: the display will
change to
• press -1 and +1 together to enter Dealer
Calibration mode
For more information on SmartPilot settings, refer to Chapter 3:
Note:
At the CAL ? screen, press

Set the vessel type

When you select a vessel type, the SmartPilot automatically selects appropriate
default values for various other calibration settings.
Some of these settings will be checked later in this procedure and the remained
should not require any adjustment. The default values for each vessel type are
listed on
DISPLAY CAL
screen
CAL?
-1
page 57
.
ST7001 /ST7002 and ST8001/ST8002
Controllers
• press and hold the standby key for two
seconds to enter the Calibration mode
, • when the screen shows
press the disp, up or down arrow
key until you see the
screen
• press the auto key: the display will
change to
• press -1 and +1 together (ST7001/
ST7002) or press up and down arrow
keys together (ST8001/ST8002)
to enter Dealer Calibration mode
+ together to enter DEALER CAL
+1
or
+
(ST8001 & ST8002 only)
DISPLAY CAL
DEALER CAL
CAL?
23
,
D6322-2