Display Calibration - Raymarine SmartPilot ST6001 Commissioning Manual

Chapter 3: Adjusting SmartPilot Settings
difficult than the other groups. After pressing auto, the display will show
CAL ?. When you see this, press the -1 and +1 keys (or the up and down
arrow keys) together to enter Dealer Calibration.
4. When you have entered one of the Calibration groupings, press disp key to
scroll down through the items within that grouping:
You can go backwards through the list by pressing and holding the disp key for one
Note:
second.
5. When you reach an item you wish to adjust, use the -1, +1, -10 and +10 keys
or the rotary control (as appropriate) to change the value.
6. If you then want to adjust settings in another Calibration group, press
standby and then repeat steps 2 to 5 as necessary.
7. When you have made all the changes you want to make, press and hold
standby for two seconds to exit Calibration mode and save changes.

3.2 Display Calibration

Display Calibration allows you to select the type of bar graph and heading shown
on the SmartPilot display, and set the information to be shown on the data pages.
Accessing Display
Calibration
Display Calibration
Data pages
Press disp
for next page
2 seconds
(save changes)
To adjust values
ST6001, ST7001,
ST6002 & ST7002
or
or
ST8001 & ST8002
D6408-2
41