Chapter 4: Calibration
4.3 Intermediate calibration
Intermediate calibration enables you to:
• Check the instrument software version.
• Check and if necessary set, the instrument status - either MASTR
Follow the procedure in the Intermediate calibration flow diagram.
4.4 Dealer calibration
Dealer calibration enables you to set:
• User calibration on/off.
• Boat show mode on/off.
Dealer calibration also gives access to the Factory defaults screen.
This enables you to reapply the factory settings if you want to reset the
instrument to a known operating condition.
Follow the procedure in the Dealer calibration flow diagram.
(master) or REPTR (repeater).
INTERMEDIATE CALIBRATION
During normal operation
hold down
Software
version
Instrument
status
To save your settings and return to normal operation from either screen,
hold down
and
and
for approximately 4 seconds
Note:
If there is no key activity when
the Software version screen
is displayed, calibration will
time out to normal operation
after 5 seconds,
CAL
for approximately 2 seconds
23
D4615-2