Chapter 4: Calibration
4.3 Intermediate calibration
The intermediate calibration screens enable you to check:
• The instrument software version number. This information is
• The instrument status - either r0 (master) or r1 (repeater).
To use the Intermediate calibration screens, hold down the disp and
true/app. keys for approximately 4 seconds.
Leaving Intermediate calibration
Hold down the disp and true/app keys for 2 seconds to exit
Intermediate calibration and resume normal operation.
4.4 Dealer calibration
The Dealer calibration procedures enable the following parameters to
be set:
• User calibration on/off.
• Wind angle and speed response.
• Velocity Made Good (VMG) response.
• Wind speed calibration.
• Boat show mode on/off.
normally required if you request parts or repairs.
Hold down
Software
version
Instrument
Intermediate calibration
true
and
disp
app
CAL
TRUE
APP
disp
status
TRUE
APP
for approximately 4 seconds
27
D4319-1