Selecting Clutch Voltage (S3 & S3G Only) - Raymarine SmartPilot ST6001 Commissioning Manual

16
CAUTION:
Do NOT connect the solenoid return cables to boat's negative
ground, as this will bypass the current protection devices inside
the SmartPilot computer.
SmartPilot S2 & S3 connections
If electronic steering or jog lever is
used on the same solenoids, fit
diodes (suggested type: 1N4004)
as indicated to prevent
backfeeding the course computer.
Selecting clutch voltage (S3 & S3G only)
You can use the S3 and S3G SmartPilot computers with other manufacturers'
drives that have either 12 V or 24 V clutches. If you do this, you may have to
reposition the clutch fuse.
Important: All Raymarine 12 V and 24 V drive units with a clutch have a 12 V
clutch, so you do NOT need to re-position the clutch fuse.
If you are using another manufacturer's drive, ascertain the operating voltage of
the CLUTCH. Ensure the clutch fuse is set to the correct voltage, i.e. to the left for
a 12 V clutch, or right for a 24 V clutch. If necessary, select the appropriate clutch
voltage by re-positioning the clutch fuse.
It is important to appreciate that the fuse position does NOT depend on the
voltage used on your boat, but on the operating voltage of the CLUTCH.
Fuse position: 12 V CLUTCH
Electronic steering
or jog lever
12 V
24 V
4
SmartPilot Series Commissioning Guide
Diodes
Spool valves
(diodes across
spool valves)
Fuse position: 24 V CLUTCH
Return cables
D5397-3
4
D5398-3