Installing the power button
1. Place the power button to its slot in the system.
2. Replace the screws to secure the power button to the system.
3. Connect the power cable to the connector in the fingerprint board.
4. Close the display hinge and secure it with the two M2.5 x 4 screws to the system.
5. Install the:
a.
Input output(I/O) board
b.
WLAN
c.
base cover
6. Follow the procedure in
System board
Removing the system board
1. Follow the procedure in
2. Remove the:
a.
base cover
b.
battery
c.
system fan
d.
heat sink
26
Removing and installing components
After working inside your
Before working inside your
computer.
computer.