Installing the power button
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power button and provides a visual representation of the installation
procedure.
Figure 35. Installing the power button
Steps
1. Place the power button in the slot on the palm-rest and keyboard assembly.
2. Align the screw hole on the power button to the screw hole on the palm-rest and keyboard assembly.
3. Replace the screw (M2x2.3) that secure the power button to the palm-rest and keyboard assembly.
Next steps
1. Install the
I/O
board.
2. Install the
base
cover.
3. Follow the procedure in
74
Removing and installing Field Replaceable Units (FRUs)
After working inside your
computer.