Dell Vostro 5470 Owner's Manual

Dell Vostro 5470 Owner's Manual

Owners manual
Hide thumbs Also See for Vostro 5470:

Advertisement

Dell Vostro 5470
Owner's Manual
Regulatory Model: P41G
Regulatory Type: P41G002

Advertisement

Table of Contents
loading

Summary of Contents for Dell Vostro 5470

  • Page 1 Dell Vostro 5470 Owner's Manual Regulatory Model: P41G Regulatory Type: P41G002...
  • Page 2 Blu-ray Disc Association (BDA) and licensed for use on discs and players. The Bluetooth word mark is a registered ® trademark and owned by the Bluetooth SIG, Inc. and any use of such mark by Dell Inc. is under license. Wi-Fi is a registered ® ®...
  • Page 3: Table Of Contents

    Contents 1 Working on Your Computer....................... 5 ........................5 Before Working Inside Your Computer ............................6 Turning Off Your Computer ........................6 After Working Inside Your Computer 2 Removing and Installing Components..................7 ..............................7 Recommended Tools ..............................7 System Overview ............................8 Removing the Base Cover ............................10 Installing the Base Cover...
  • Page 4 System Setup Options 4 Troubleshooting.........................37 ................37 Enhanced Pre-Boot System Assessment (ePSA) Diagnostics .............................. 37 Battery Status Lights ............................... 38 Device Status Lights ................................38 Beep Codes 5 Specifications..........................39 ............................39 Technical Specification 6 Contacting Dell.......................... 45 ............................... 45 Contacting Dell...
  • Page 5: Working On Your Computer

    Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • Page 6: Turning Off Your Computer

    CAUTION: To connect a network cable, first plug the cable into the network device and then plug it into the computer. Connect any telephone or network cables to your computer. Connect your computer and all attached devices to their electrical outlets. Turn on your computer. If required, verify that the computer works correctly by running the Dell Diagnostics.
  • Page 7: Removing And Installing Components

    Removing and Installing Components This section provides detailed information on how to remove or install the components from your computer. Recommended Tools The procedures in this document may require the following tools: • Small flat-blade screwdriver • Phillips screwdriver • Small plastic scribe System Overview The figure below displays the inside view of the back of the computer after the base cover has been removed.
  • Page 8: Removing The Base Cover

    7. hard drive 8. system fan 9. system board 10. memory module 11. heatsink Removing the Base Cover Before Working Inside Your Computer . Follow the procedures in Remove the screws that secure the base cover to the computer. Pry the base cover along the edges to loosen it.
  • Page 9 Lift and remove the base cover from the computer.
  • Page 10: Installing The Base Cover

    Installing the Base Cover Place the base cover to align with the screw holes on the computer. Tighten the screws to secure the base cover to the computer. After Working Inside Your Computer . Follow the procedures in Removing the Battery Before Working Inside Your Computer .
  • Page 11 Lift and remove the battery from the computer.
  • Page 12: Installing The Battery

    Installing the Battery Place the battery into its slot until it clicks into place. Connect the battery cable to its connector on the system board. Install the base cover. After Working Inside Your Computer. Follow the procedures in Removing the Hard Drive Before Working Inside Your Computer .
  • Page 13: Installing The Hard Drive

    Installing the Hard Drive Place the hard drive assembly into its slot on the computer. Install: a) battery b) base cover After Working Inside Your Computer. Follow the procedures in Removing the Coin-Cell Battery Follow the procedures in Before Working Inside Your Computer . Remove : a) base cover b) battery...
  • Page 14: Installing The Coin-Cell Battery

    Installing the Coin-Cell Battery Place the coin-cell battery into its slot on the computer. Route the coin-cell battery cable along the routing channel. Connect the coin-cell battery cable to its connector on the system board. Install : a) battery b) base cover After Working Inside Your Computer.
  • Page 15: Removing The Msata Ssd Card

    Removing the mSATA SSD Card Before Working Inside Your Computer . Follow the procedures in Remove: a) base cover b) battery Remove the screw that secures the mSATA SSD card to the computer. Remove the mSATA SSD card from its slot on the system board. Installing the mSATA SSD Card Insert the mSATA SSDcard into its connector at a 45–degree angle.
  • Page 16 Lift and remove the left system fan from the computer. Disconnect the right system fan cable from its connector on the system board. Peel away the system board flex cable from the right system fan.
  • Page 17 Remove the screws that secure the right system fan to the system board. Lift and remove the right system fan from the computer.
  • Page 18: Installing The System Fan

    Installing the System Fan Place the right system fan into its original position in the system board and affix the system board flex cable. Tighten the screws that secure the right system fan to the system board. Connect the right system fan cable to its connector on the system board. Place the left system fan into its original position in the system board.
  • Page 19 Lift up the heatsink and remove from the computer.
  • Page 20: Installing The Heatsink

    Installing the Heatsink Place the heatsink into its original position on the system board. Tighten the screws to secure the heatsink to the system board. Install: a) system fan b) battery c) base cover After Working Inside Your Computer. Follow the procedures in Removing the Memory Before Working Inside Your Computer .
  • Page 21 b) display c) keyboard d) touchpad e) camera f) coin-cell battery g) WLAN h) Finger printer Remove the screws that secure the system board to the chassis.
  • Page 22 Remove the system board from the computer.
  • Page 23: Installing The System Board

    Installing the System Board Place the system board into its original position on the chassis. Tighten the screws to secure the system board to the chassis. Connect the following cable: a) finger printer b) WLAN c) coin-cell battery d) camera e) touchpad f) keyboard g) display...
  • Page 24 Lift the speaker assembly along with the routing cable and remove the speakers from the computer.
  • Page 25: Installing The Speakers

    Installing the Speakers Place the speakers into its original position on the computer. Route the speaker cable along the routing channel. Connect the speaker connector to its slot on the system board. Install: a) system board b) heatsink c) system fan d) coin-cell battery e) mSATA SSD card f) WLAN card...
  • Page 26 Remove the screws that secure the display hinges to the system board. Lift and move the system base panel away from the display hinges to facilitate easy removal of the display assembly. Remove the system base panel.
  • Page 27: Installing The Display Assembly

    Installing the Display Assembly Align the base panel of the computer to the display hinges. Install the screws that secure the display hinges to the system board. Connect the LVDS cable and the camera cable to the connectors on the system board. Install : a) battery b) base cover...
  • Page 28 Pry on the plastic caps that cover the display bezel screws and remove them. Remove the screws that secure the screws to the display bezel.
  • Page 29 Pry along the inner edges of the display bezel and remove the display bezel.
  • Page 30: Installing The Display Bezel

    Installing the Display Bezel Align the display bezel by pressing along the edges. Install the screws that secure the display bezel. Install the plastic caps that secure the display bezel screws on both sides of the display. Install : a) battery b) base cover c) display assembly After Working Inside Your Computer.
  • Page 31: Installing The Display Panel

    Installing the Display Panel Align the display panel to the display assembly by pressing along the edges. Install the screws that secure the display. Install: a) battery b) base cover c) display assembly d) display bezel After Working Inside Your Computer. Follow the procedures in Removing the Camera Before Working Inside Your Computer .
  • Page 32: Installing The Camera

    Installing the Camera Align the camera to the base panel . Connect the camera cable to the camera. Install : a) battery b) base cover c) display assembly d) display bezel e) display After Working Inside Your Computer. Follow the procedures in...
  • Page 33: System Setup

    Boot Sequence allows you to bypass the System Setup‐defined boot device order and boot directly to a specific device (for example: optical drive or hard drive). During the Power-on Self Test (POST), when the Dell logo appears, you can: •...
  • Page 34: Updating The Bios

    Restart the computer. Go to dell.com/support. If you have your computer's Service Tag or Express Service Code: NOTE: To locate the Service Tag, click Where is my Service Tag? NOTE: If you cannot find your Service Tag, click Detect Service Tag.
  • Page 35 Table 2. Main System Time Re-sets the time on the computer's internal clock. System Date Re-sets the date on the computer's internal calendar. BIOS Version Displays the BIOS revision. Product Name Displays the product name and the model number. Service Tag Displays the service tag of your computer.
  • Page 36 Intel Rapid Start Technology Enable or disable Inter Rapid Start Deafult: Enable Technology. Miscellaneous Devices These fields let you enable or disable various on-board devices. Battery Health Displays a message about the battery health. Security Table 4. Security Set Asset Tag This field displays your system's asset tag.
  • Page 37: Troubleshooting

    Power-on the computer. As the computer boots, press the <F12> key as the Dell logo appears. On the boot menu screen, select the Diagnostics option. The Enhanced Pre-boot System Assessment window is displayed, listing all devices detected in the computer. The diagnostics starts running the tests on all the detected devices.
  • Page 38: Device Status Lights

    Battery Charge LED Off/Hibernate Standby Discharging when Battery Blinking White charge is <=10% Device Status Lights Turns on when you turn on the computer and blinks when the computer is in a power management mode. Turns on when the computer reads or writes data. Turns on steadily or blinks to indicate battery charge status.
  • Page 39: Specifications

    Specifications Technical Specification NOTE: Offerings may vary by region. For more information regarding the configuration of your computer, click Start (Start icon) → Help and Support, and then select the option to view information about your computer. NOTE: In Windows 8, navigate to Help and Support to view information about your computer. Table 7.
  • Page 40 Feature Description Volume controls Program menus and keyboard shortcut keys Table 11. Video Feature Description Video type UMA/DIS Video Controller: Intel HD Graphics 4000 Discrete Nvidia N14P-GV2 Data bus 64 bit External display support HDMI Table 12. Camera Feature Description Camera Resolution 1 Megapixel Video Resolution (maximum)
  • Page 41 Feature Description Width 326.18 mm (12.84 inches) Diagonal 14.0" Active area (X/Y) 309.4 mm (12.18 inches) x 173.95 mm (6.84 inches) Maximum resolution 1366 x 768 pixels Maximum Brightness 200 nits Operating angle 135 degree Refresh rate 60Hz / 40Hz Minimum Viewing angles: Horizontal 40 (L) / 40 ( R)
  • Page 42 Feature Description 0 ℃ to 65 ℃ Non-Operating Coin-cell battery LI 3V 83 MAH Table 19. AC Adapter Feature Description Type AC adapter Input voltage 90 ~ 264 VAC Input current (maximum) 1.6 A / 1.5 A Input frequency 50 Hz ~ 60 Hz Output power 65 W / 90 W Output current...
  • Page 43 Non-Operating –15.2 m to 10,668 m (–50 ft to 35,000 ft) Airborne contaminant level G2 or lower as defined by ISA - S71.04 – 1985...
  • Page 45: Contacting Dell

    Dell product catalog. Dell provides several online and telephone-based support and service options. Availability varies by country and product, and some services may not be available in your area. To contact Dell for sales, technical support, or customer service issues: Visit dell.com/support...

Table of Contents